HEADING_CONTACT_US_POPUP_TITLE

HEADING_CONTACT_US_POPUP_SUBTITLE

Fuel Pump Kit

Fuel Pump Kit

Complete Kits to Install Belt Drive Fuel Pump

These kits include:

• Fuel pump
• Outlet fitting is a -8AN
• Inlet fitting is available in a -8, -10, or a -12AN
• Standard drive is 50% with a 14-28th combination
• Fuel pump pulley is available in 28 or 32 tooth
• Crankshaft drive gear is available in 14 or 16 tooth
• Drive gear belt guards (2)
• Crankshaft drive mandrel with bolt and hat washer
• Belt
• All mounting hardware

Note: You must specify pump drive ratio desired. If you are not sure then we can assist you in this choice. Specify if you want a -8 or -10 inlet fitting. The last 3 numbers of the part number indicate the size of the pump.
Example: 7412CR-500 is a kit with a .500 gear pump. A right hand pump is mounted on the passenger side and a left hand pump is mounted on the driver side.

Recommendation for Pump Selection:

• Right hand pumps are mounted on the
passenger’s side.
• Left hand pumps are mounted on the driver’s side.
• The standard outlet fitting is a -8AN, but you can substitute a -10AN or -12AN.
• The last 3 numbers of the part number indicate the pump gear size. Example: a 7400-.500 is an internal by-pass fuel pump with .500” wide gears.
• Kits are available with or without a drive mandrel.
• The kits without the mandrel include the 1.000” I.D. drive gear and (2) belt guards.
• For dry sump engines order the kit without a mandrel and then add the appropriate mandrel.